 |
Swimming-pool sector |
| Turning panels |
|
Swimming-pool sector |
| Turning panels |
| FINA regulations |
| Panel height 33cm. Panel must be vertical, perfectly parallel and directly flush with the pool edge. The bottom edge of the panel must be at water level. |
| Dimensions |
| Height: 33cm Thickness: 4cm Length: equal to swimming lane width less 6cm each side to allow for lane lines. |
| Material |
| All the stainless steel used in making these panels is AISI 304. |
| Electronic timing The turning panels are compatible with all electronic timing equipment available on the market. Position vis-à-vis pool edge: Positioning of the turning panel supports depends on the type of pool edge. It is most important that the distance between the pool edge and the anchor socket (the distance ‘L’ shown on the diagram below) is the shortest possible (the minimum possible distance is 17cm). |
 |
Scheme n. 1 |
|
 |
Scheme n. 2 |
|
 |
Scheme n. 3 |
|
 |
Model PLK/2
P2511 Panel with two support assemblies |
|
 |
Scheme n. 4 |
|
 |
 |
 |
